Safe Manual

PRIMARY & SECONDARY USER CODES (Cont.)

TEST THE PRIMARY USER CODE

1. With door open, rotate handle counterclockwise to put door bolts in lock

position.

2. Enter the new 3-8 digit Primary user code followed by the # key. The green

LED will light up and the keypad will beep.

3. Rotate the spindle handle clockwise within 5 seconds.

4. The lock bolts should recede into the unlocked position when the handle is

turned.

REPROGRAM A NEW PRIMARY USER CODE

In the future, this user code can always be changed by opening the safe and

using the reset button.

1. Once the safe door is open, locate and press the small reset button located on

the inside edge of the door, the keypad will beep twice and the green LED will

light up.

2. Enter a new 3-8 digit Primary user code followed by the # key, the green LED

will again light up and the keypad will beep.

3. Immediately re-enter the new 3-8 digit user code a second time followed by

the # key and the green LED with flash twice and the keypad will beep twice.

4. This new Primary user code is now active and the old Primary user code is

deleted.