Safe Manual

UNLOCK & OPEN YOUR NEW SAFE

DOOR HANDLE

The handle spindles have been shipped inside the Styrofoam cover on the outside

of the safe door and should be installed before opening safe the first time.

UNLOCK AND OPEN THE SAFE

1. Always make sure that the spindle handle is turned counterclockwise to the left

before entering code.

2. Enter the preset factory code “1 2 3 4 5 6” followed by # key into the keypad.

3. If the correct code is entered, the keypad will beep once, the green LED will light

up and you will hear a click indicating the spindle handle can be turned to the

right (clockwise) to open. NOTE: You have approximately 5 seconds to open the

safe. If you wait any longer, the safe will relock and you will have to reenter the

code to open.

PRIMARY & SECONDARY USER CODES

Your new safe is equipped with a digital lock that can be operated with two

separate user codes. You will need to program these user codes with your own

3-8 digit user codes. It is recommended that you record your new user codes

and keep in a secure location away from the safe. You must program the Primary

user code first. After the Primary user code is programmed and tested you can

then proceed to program the Secondary user code.

PRIMARY USER CODE

UNLOCK AND OPEN SAFE

IMPORTANT: Always make sure that the spindle handle is turned

counterclockwise to the left before entering user code.

1. Open your new safe by entering 1-2-3-4-5-6 followed by the # key on the

keypad.

2. After user code is entered, the keypad will beep once and the green LED will

light up.

3. Turn the spindle handle to the right (clockwise) to open.

NOTE: You must open the safe within 5 seconds or the safe will relock.

PROGRAM THE PRIMARY USER CODE

1. With door open, locate and press the red reset button

located on the inside edge of the door (see

illustration), the keypad will beep twice and the green

LED will light up.

2. Enter a new 3-8 digit Primary user code followed by

the # key. The green LED will light up and the keypad

will beep.

3. Immediately re-enter the new 3-8 digit user code a

second time followed by the # key and the green LED

will flash twice and the keypad will beep twice.

4. This new Primary user code is now active.