Install Instructions

204718A,C COVER ASSEMBLY FOR S7800 KEYBOARD DISPLAY MODULE
65-0151—3 2
ORDERING INFORMATION
When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the
TRADELINE® Catalog or price sheets for complete ordering number.
If you have additional questions, need further information, or would like to comment on our products or services, please write or
phone:
1. Your local Honeywell Automation and Control Products Sales Office (check white pages of your phone directory).
2. Honeywell Customer Care
1885 Douglas Drive North
Minneapolis, Minnesota 55422-4386
In Canada—Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Toronto, Ontario M1V 4Z9.
International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France,
Germany, Japan, Mexico, Netherlands, Spain, Taiwan, United Kingdom, U.S.A.
1. Disconnect power supply to prevent electrical shock
and/or equipment damage.
2. Place the tabs on the bottom of the S7800 Keyboard
Display Module into the slots below the scroll panel on
the cover. See Fig. 1.
3. Push the S7800 down into the slots while moving the
top of the S7800 forward. The S7800 will snap into
place at the top of the cover.
4. Connect the S7800 Keyboard Display Module to the
system using the 203541 5-Wire Connector provided,
following the installation procedure of the S7800
Keyboard Display Module
5. Position the cover over the panel and secure with eight
No. 6 x 1/2 in. sheet metal screws (obtained locally). For
the 204718A,C NEMA 4 Cover Assembly, tighten the
screws so that the cover assembly is flush with the
panel. This compresses the gasket and forms a NEMA
4 seal.
6. Restore power and perform checkout of the S7800
Keyboard Display Module as described in the applicable
specification(s).
Fig. 1. Installing S7800 Keyboard Display Module in 204718 Cover Assembly.
BURNER CONTROL
SCROOL
MODE
SAVE
S7800
COVER
S7800
COVER
M23869
1
1
CONNECT TWO LEADWIRES FROM RESET BUTTON OF 204718C TO TERMINALS 3 AND 5 OF
S7800 5-WIRE CONNECTOR (REFER TO S7800 INSTALLATION INSTRUCTIONS, FORM 65-0090).