User Manual

Xenon XP User Guide 53
scanner to shut down when in the base cradle, scan Shut Down Scanner in Cradle.
Default for CCB01-010BT = Scan in Cradle On. Default for CCB-H-010BT = Scan in
Cradle Off.
Base Charge Modes
When the base has both an external power supply (plugged into the auxiliary power
port) and a host interface cable, it will draw its power from the external power sup-
ply. When the base does not have an external power supply, it draws its power from
the interface cable. However, the scanner charges more slowly from a host inter-
face cable than if auxiliary power were available. Using the following selections,
you can specify whether the scanner is charged from power supplied via the host
interface cable.
When Base Charge Off is selected, the scanner does not charge when the scanner
is in the base cradle.
When External or Interface Cable Power is selected, the scanner charges from the
base’s external power supply, if there is one. If there is no external power supply to
the base, the scanner charges from the interface cable.
When External Power Only is selected, the scanner only charges from the base’s
external power supply. If there is no external power supply, the scanner does not
charge.
Note: If you are using a cordless charge base in Presentation Mode, External Power Only
is the only setting available.
Default = External or Interface Cable Power.
Scan in Cradle Off
Scan in Cradle On
Shut Down Scanner in Cradle
Base Charge Off