User Manual

CHAPTER
5
Xenon XP User Guide 117
HEALTHCARE SETTINGS
The following settings have been developed to enhance scanning in a healthcare
environment. These settings are only supported by the Xenon XP 1950h scanner,
Xenon XP 1952h, and Xenon XP 1952h-BF scanner and base. They allow you to set
quickly configure streaming presentation, and to set the scanner and base to quiet
modes for scanning that do not disturb resting patients.
Quiet Operations - Combination Codes
The following combination codes program your Xenon XP healthcare scanner and
base for silent or quiet settings using a single programming code. If you wish to
program some of these quiet settings individually, refer to Quiet Operations - LED
and Volume Settings, beginning on page 119.
Silent Mode with Flashing LED
Scan the following bar code to completely silence the Xenon XP scanner and base.
The scanner beep, base beep, base and scanner power up beep, and scanner link-
ing sounds are all silenced. When a bar code is scanned, the LED and aimer flash 5
times. Green indicates a good scan, red indicates a bad scan.
Silent Mode with Flashing LED -
Cordless Scanner and Base
Silent Mode with Flashing LED -
Corded Scanner