User manual

14 Xenon/Granit User Guide
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This is the recommended default bar code for
most users. It resets the scanner to the custom default settings. If there are no cus-
tom defaults, it will reset the scanner to the factory default settings. Any settings
that have not been specified through the custom defaults will be defaulted to the
factory default settings.
Note: If using a cordless system, scanning this bar code also causes both the scanner and
the base or Access Point to perform a reset and become unlinked. The scanner must
be placed in its base to re-establish the link. If using an Access Point, the linking bar
code must be scanned. See Cordless System Operation: Xenon 1902g/1912 and
Granit 1911i/1981i beginning on page 41,or Cordless System Operation: Xenon
1902g-BF beginning on page 79 for additional information.
Activate Custom Defaults