User manual

92 Xenon/Granit User Guide
Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the bar code below and then scan
a digit (1-9) from the Programming Chart, beginning on page 351, then Save.
Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanner. The report
indicates the port, scanner name, and address. To assign a name to your scanner,
refer to Menu Command Syntax,page 265.
Scanner Address
Scan the bar code below to determine the address of the scanner you are using.
* Razz (250 Hz)
Medium (3250 Hz)
High (4200 Hz)
Number of Base Error Beeps/LED Flashes
Scanner Report
Scanner Address