User manual

11 - 13
Character Activation Mode *Off HSTCEN0 4-13
On HSTCEN1 4-13
Activation Character (Range 0-
255) *12 [DC2]
HSTACH### 4-14
*Do Not End Character Activation
After Good Read
HSTCGD0 4-14
End Character Activation After
Good Read
HSTCGD1 4-14
Character Activation Timeout
(Range 1 - 300,000) *30,000 ms
HSTCDT###### 4-14
Character Deactivation Mode *Off HSTDEN0 4-14
On HSTDEN1 4-14
Deactivation Character (Range 0-
255) *14 [DC4]
HSTDCH### 4-15
Illumination Lights *Lights On SCNLED1 4-15
Lights Off SCNLED0 4-15
Aimer Delay 200 milliseconds SCNDLY200 4-15
400 milliseconds SCNDLY400 4-15
*Off (no delay) SCNDLY0 4-15
User-Specified Aimer Delay Range 0 - 4,000 ms SCNDLY#### 4-16
Aimer Mode Off SCNAIM0 4-16
*Interlaced SCNAIM2 4-16
Centering Window Centering On DECWIN1 4-17
*Centering Off DECWIN0 4-17
Left of Centering Window (*40%) DECLFT### 4-17
Right of Centering Window (*60%) DECRGT### 4-18
Top of Centering Window (*40%) DECTOP### 4-17
Bottom of Centering Window
(*60%)
DECBOT### 4-17
Preferred Symbology On PRFENA1 4-18
*Off PRFENA0 4-18
High Priority Symbology PRFCOD## 4-18
Low Priority Symbology PRFBLK## 4-19
Preferred Symbology Timeout
(*500) Range 100-3000
PRFPTO#### 4-19
Preferred Symbology Default PRFDFT 4-19
Output Sequence Editor Enter Sequence SEQBLK 4-21
Default Sequence SEQDFT 4-21
Partial Sequence Transmit Partial Sequence SEQTTS1 4-21
*Discard Partial Sequence SEQTTS0 4-21
Require Output Sequence Required SEQ_EN2 4-22
On/Not Required SEQ_EN1 4-22
*Off SEQ_EN0 4-22
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page