User manual

11 - 8
RS232 Receiver Time-out Range 0 - 300 seconds 232LPT### 2-20
RS232 Handshaking *RTS/CTS Off 232CTS0 2-20
Flow Control, No Timeout 232CTS1 2-20
Two-Direction Flow Control 232CTS2 2-20
Flow Control with Timeout 232CTS3 2-20
RS232 Timeout 232DEL#### 2-20
*XON/XOFF Off 232XON0 2-21
XON/XOFF On 232XON1 2-21
*ACK/NAK Off 232ACK0 2-21
ACK/NAK On 232ACK1 2-21
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 2-21
Packet Mode On 232PKT2 2-2
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 2-22
Bioptic ACK/NAK On 232NAK1 2-22
Scanner-Bioptic ACK/NAK Timeout ACK/NAK Timeout
*5100
232DLK##### 2-22
Cordless System Operation
Note: This section applies only to cordless systems. It does not apply to corded scanners.
Base Power Communication
Indicator
*On :*:BASRED1 3-5
Off :*:BASRED0 3-5
Reset Scanner Reset Scanner RESET_ 3-6
Scanning While in Base Cradle Scanning in Cradle Off BT_SIC0 3-6
*Scanning in Cradle On (CCB01-
010BT default)
BT_SIC1 3-6
Shut Down Scanner in Cradle BT_SIC2 3-6
Base Charging Modes Base Charge Off BASCHG0 3-7
*External or Interface Cable Power BASCHG1 3-7
External Power Only BASCHG2 3-7
Paging Mode *On BEPPGE1 3-7
Off BEPPGE0 3-7
Paging Pitch Range 400 - 9000 Hz (*1000) BEPPFQ#### 3-7
Beeper Pitch - Base Error *Razz (250) (min 200Hz) BASFQ2250 3-8
Medium (3250) BASFQ23250 3-8
High (4200) (max 9000Hz) BASFQ24200 3-8
Number of Beeps - Base Error *1 BASERR3 3-8
Range 1 - 9 BASERR# 3-8
Scanner Report Scanner Report RPTSCN 3-8
Scanner Address Scanner Address BT_LDA 3-9
Base Address Base Address :*:BASLDA 3-9
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page