User's Guide

60 HH1800 User Guide
If you have changed data format settings, and wish to clear all formats and return to the
factory defaults, scan the Default Data Format code below.
* Default Data Format
Show Data Format
Scan the barcode below to show current data format settings.
Data Format Settings
Add a Data Format
Step 1. Scan the Enter Data Format symbol (page 61).
Step 2. Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate formats.
This allows you to save a total of 4 different data formats. To program your primary
format, scan 0 from the Programming Chart, beginning on page 211. If you are
programming an alternate format, scan 1, 2, or 3, depending on which alternate
format you are programming. (See Primary/Alternate Data Formats on page 78 for
further information.)
Step 3. Terminal Type
Refer to Terminal ID Table (page 62) and locate the Terminal ID number for your PC.
Scan three numeric barcodes from the Programming Chart, beginning on page 211,
to program the scanner for your terminal ID (you must enter 3 digits). For example,
scan 0 0 3 for an AT wedge.
Note:
099 indicates all terminal types.
Step 4. Code I.D.
In the Symbology Charts, beginning on page 200, find the symbology to which you
want to apply the data format. Locate the Hex value for that symbology and scan
the 2 digit hex value from the Programming Chart, beginning on page 211.
If you wish to create a data format for all symbologies, with the exception of some
specific symbologies, refer to B8 (page 76).
If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.