User's Guide

HH1800 User Guide 57
1
2
3
4
5
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed
between the transmission of each character of scanned data. Scan the Intercharacter Delay
barcode below, then scan the number of 5ms delays from the Programming Chart, beginning
on page 211, then Save.
Intercharacter Delay
To remove this delay, scan the Intercharacter Delay barcode, then set the number of delays
to 0. Scan the Save barcode from the Programming Chart, beginning on page 211.
Note:
Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed after
the transmission of a particular character of scanned data. Scan the Delay Length barcode
below, then scan the number of 5ms delays from the Programming Chart, beginning on page
211, then Save.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a printable
character to trigger the delay (see Lower ASCII Reference Table, page 205.)
Delay Length
Character to Trigger Delay
To remove this delay, scan the Delay Length barcode, and set the number of delays to 0. Scan
the Save barcode from the Programming Chart, beginning on page 211.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be placed between
Intercharacter Delay
Prefix
Scanned Data
Suffix