User's Guide

34 HH1800 User Guide
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below, then set the
delay (from 0-30,000 milliseconds) by scanning digits from the Programming Chart, beginning
on page 211, then Save.
User-Specified Reread Delay
2D Reread Delay
Sometimes 2D barcodes can take longer to read than other barcodes. If you wish to set a
separate Reread Delay for 2D barcodes, scan one of the programming codes that follows. 2D
Reread Delay Off indicates that the time set for Reread Delay is used for both 1D and 2D
barcodes. Default = 2D Reread Delay Off.
* 2D Reread Delay Off
Short (1000ms)
Medium (2000ms)
Long (3000ms)
Extra Long (4000ms)
Character Activation
You may use a character sent from the host to trigger the scanner to begin scanning. When
the activation character is received, the scanner continues scanning until either the Character
Activation Timeout (page 46) is reached, the deactivation character is received (see
Deactivation Character on page 46), or a barcode is transmitted. Scan the On barcode to use
character activation, then use Activation Character (page 45) to select the character you will
send from the host to start scanning. Default = Off.