User's Guide

HH1800 User Guide 131
Digimarc Barcode™
Digimarc Decoder Attempts
Set the number of attempts by scanning the barcode below, then setting the number of
attempts (0-10) by scanning digits from the Programming Chart beginning on page 211 of this
manual, the Save. Minimum to Maximum attempts = 0-10. Default = 5.
Digimarc Decoder Attempts
Digimarc Barcode
This setting programs the scanner to decode Digimarc Barcode using Digimarc and ID
decoders. When Digimarc Barcode is set to On, the Digimarc decoder is used on most frames
and the ID decoder will read every fifth frame.
When Digimarc Barcode is set to Uses ID Decoder then Both Decoders, the ID decoder will
read the number of attempts set by the Digimarc Decoder Attempts and then will use both ID
and Digimarc decoders. When Digimarc Barcode is set to Uses Digimarc Decoder then Both
Decoders, the Digimarc decoder will read the number of attempts set by the Digimarc
Decoder Attempts and then will use both ID and Digimarc decoders.
When Digimarc Barcdoe is set to Uses ID Decoder then Alternates Decoders, the ID decoder
will read the number of attempts set by the Digimarc Decoder Attempts and then will
alternate between ID and Digimarc decoders. When Digimarc Barcode is set to Uses Digimarc
Decoder then Alternates Decoders, the Digimarc decoder will read the number of attempts
set by the Digimarc Decoder Attempts and then will alternate between ID and Digimarc
decoders.
Default = Uses Digimarc Decoder then Both Decoders.
*Off
On
Uses ID Decoder then Both Decoders