User's Guide

3 - 14
Scan the linking bar code on the top of the Access Point to establish a connection between the Access Point and the scan-
ner. The scanner emits a short beep and flashes the green LED to confirm a connection with the Access Point. The
Access Point’s Page button remains blue.
If the Access Point sounds 5 error tones followed by 3 beeps, it indicates that you are attempting to link to the incorrect
model Access Point. The Voyager 1602g scanner can only link to an Access Point model AP01-010BT or AP01-100BT.
Disconnect from Host and Connect to an Access Point
If your scanner has been connected directly to an iPad, smart phone, or laptop, you must disconnect it in order to commu-
nicate with an Access Point. Scan the Bluetooth HID Keyboard Disconnect bar code to unlink the scanner from the cur-
rently linked host. Scan the linking bar code on the Access Point to link the scanner to the Access Point.
Replacing a Linked Scanner
If you need to replace a broken or lost scanner that is linked to an Access Point, scan the Override Locked Scanner bar
code below with a new scanner and scan the Access Point linking bar code. The locked link will be overridden; the broken
or lost scanner’s link with the Access Point will be removed, and the new scanner will be linked.
Bluetooth HID Keyboard Disconnect
Override Locked Scanner
(Single Scanner)
VG1602-UG C Released Honeywell proprietary & Confidential
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Downloaded By: Shen, Scott - 16 June 2022 07:14:56 UTC HEC: EAR99 TEC: EAR99 GOV: ESO1.0