User's Guide

3 - 8
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a host, scan the Override Locked Scanner bar code below
with a new scanner and pair that scanner with the host. The locked link will be overridden; the broken or lost scanner’s link
with the host will be removed, and the new scanner will be linked.
Out-of-Range Alarm
Note: This feature is only supported by a Honeywell Access Point (AP). See Access Point Operations, beginning on page 3-13
for further information.
If your scanner is out range of the AP, an alarm sounds from the scanner. The alarm stops when the scanner is moved closer to
the AP, when the AP links to another scanner, or when the alarm duration expires. To set the alarm duration, scan the bar code
below and then set the time-out duration (from 0-3000 seconds) by scanning digits on the Programming Chart inside the back
cover, then scanning Save. Default = 0 sec (no alarm).
Note: If you are out of range when you scan a bar code, you will receive an error tone even if you do not have the alarm set
because the data could not be communicated to the AP.
Alarm Sound Type
Change the alarm type by scanning the following bar code and then scanning a digit (0-7) bar code and the Save bar code
on the Programming Chart inside the back cover of this manual. Default = 0.
The sounds are as follows:
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
2 4 short beeps, medium pitch
3 4 short beeps, high pitch
4 single chirps, medium pitch
5 2 chirps, then 1 chirp, medium pitch
6 single chirps, high pitch
7 2 chirps, then 1 chirp, high pitch
Override Locked Scanner
(Single Scanner)
Scanner Alarm Duration
Scanner Alarm Type
VG1602-UG C Released Honeywell proprietary & Confidential
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Downloaded By: Shen, Scott - 16 June 2022 07:14:56 UTC HEC: EAR99 TEC: EAR99 GOV: ESO1.0