User Manual

1. Insert key into lock cylinder (Figure 1.1).

2. Turn the key counterclockwise to the left ¼ turn (Figure 1.2).

3. With key lock in the unlocked position, turn the knob to the right to the

unlocked position (Figure 1.3).

4. While holding the knob in the unlocked position, lift the lid to open

(Figure 1.4).

Note: The knob will return to the locked position when released.

5. Slide battery compartment cover open and install 4 AAA batteries over the

ribbon in the right orientation (Figure 1.5). Replace the battery cover.

6. LED will ﬂash Green and Red 3 times (Figure 1.6).

INITIAL SETUP

Figure 1.1

Figure 1.2

Figure 1.3 Figure 1.4

Figure 1.5a Figure 1.5b

Figure 1.6

Factory default passcode is 1-2-3-4-1-2

Remember to change user passcode to new user 6 digit passcode, once

the passcode is changed, the factory default passcode will no longer work.

1. Enter factory default passcode (Figure 1.7), with each digit entry, the LED

will ﬂash red once (Figure 1.8).

2. Each consecutive digit entry must be within 10 seconds. If the interval

is greater than 10 seconds, previous digit entries will be invalid.

3. When correct entry is entered, LED will light up green for 5 seconds and

you can turn the knob to the right to unlatch the safe and lift the lid to open.

4. If entry is incorrect, LED will ﬂash red 3 times.

5. After 3 incorrect entries, the chest will lock down for 4 minutes.

Figure 1.7 Figure 1.8