User Manual

8 - 8
Character Activation Mode *Off HSTCEN0 3-12
On HSTCEN1 3-12
Activation Character (Range 0-
255) *18 [CAN]
HSTACH### 3-12
Do Not End Character Activation
After Good Read
HSTCGD0 3-13
*End Character Activation After
Good Read
HSTCGD1 3-13
Character Activation Timeout
(Range 1 - 5000) *65,535 ms
HSTCDT###### 3-13
Character Deactivation Mode *Off HSTDEN0 3-13
On HSTDEN1 3-13
Deactivation Character (Range 0-
255) *68 [h]
HSTDCH### 3-14
Centering Window Centering On DECWIN1 3-14
*Centering Off DECWIN0 3-14
Left of Centering Window (*40%) DECLFT### 3-14
Right of Centering Window (*60%) DECRGT### 3-15
Blinky Mode *Blinky Mode Off BLKMOD0 3-15
Blinky Mode On BLKMOD1 3-15
Blinky Always On/Continuous BLKMOD2 3-15
Laser Scan Angle Full Laser Beam Sweep LASANG0 3-15
Reduced Laser Beam Sweep LASANG1 3-15
Wide Laser Beam Sweep LASANG2 3-15
Decode Security Low PAPLS1 3-16
Low/Medium PAPLS2 3-16
Medium/High PAPLS3 3-16
High PAPLS4 3-16
Continuous Scan Mode Continuous Scan Mode PAPPM3 3-16
Output Sequence Editor Enter Sequence SEQBLK 3-18
Default Sequence SEQDFT 3-18
Sequence Timeout (Range 1 - 65535) *5000 ms SEQDLY##### 3-18
Sequence Match Beeper *On SEQBEP1 3-18
Off SEQBEP0 3-18
Partial Sequence Transmit Partial Sequence SEQTTS1 3-19
*Discard Partial Sequence SEQTTS0 3-19
Require Output Sequence Required SEQ_EN2 3-19
On/Not Required SEQ_EN1 3-19
*Off SEQ_EN0 3-19
Multiple Symbols On SHOTGN1 3-20
*Off SHOTGN0 3-20
No Read On SHWNRD1 3-20
*Off SHWNRD0 3-20
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page