User Manual

8 - 6
Power Up Beeper Power Up Beeper Off - Scanner BEPPWR0 3-1
*Power Up Beeper On - Scanner BEPPWR1 3-2
Beep on BEL Character Beep on BEL On BELBEP1 3-2
*Beep on BEL Off BELBEP0 3-2
Beeper - Good Read Off BEPBEP0 3-2
*On BEPBEP1 3-2
Beeper Volume - Good Read Off BEPLVL0 3-2
Low BEPLVL1 3-2
Medium BEPLVL2 3-2
*High BEPLVL3 3-2
Beeper Pitch - Good Read
(Frequency)
Low (1600) (min 90Hz) BEPFQ11600 3-3
*Medium (3200 Hz) BEPFQ13200 3-3
High (4200) (max 5000Hz) BEPFQ14200 3-3
Beeper - Transmit Order *Before Transmission BEPWHN1
After Transmission BEPWHN2
Vibrate - Good Read Vibrate - Good Read Off TFBGRD0 3-3
*Vibrate - Good Read On TFBGRD1 3-3
Vibrate Duration Duration
(100 - 2,000 ms) *300
TFBDUR#### 3-4
Beeper Pitch - Error (Frequency) *Razz (100) (min 90Hz) BEPFQ2100 3-4
Medium (3250) BEPFQ23250 3-4
High (4200) (max 5000Hz) BEPFQ24200 3-4
Beeper Duration - Good Read *Normal Beep BEPBIP0 3-4
Short Beep BEPBIP1 3-4
Number of Beeps - Error *1 BEPERR3 3-5
Range 1 - 9 BEPERR# 3-5
Number of Beeps - Good Read *1 BEPRPT1 3-5
Range 1 - 9 BEPRPT# 3-5
Beeper Volume Max Beeper Volume Max PAPBLM 3-5
Laser Aimer - Scanning Pattern Pattern Off SCNGSI0 3-5
Laser Dot SCNGSI1 3-5
Blinking Dot SCNGSI2 3-6
3 Segment Line SCNGSI3 3-6
5 Segment Line SCNGSI4 3-6
*10 Segment Line SCNGSI5 3-6
Laser Aimer - Scanning Duration Range (0 - 65535) *0 SCNAIT##### 3-6
Laser Aimer - Good Read Pattern Off LASGSI0 3-6
3 Segment Line LASGSI3 3-6
5 Segment Line LASGSI4 3-6
*10 Segment Line LASGSI5 3-7
Laser Aimer - Good Read Duration Range (0 - 65535) *0 LASGIT##### 3-7
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page