User manual

58 Voyager 1250g User Guide
Output Sequence Editor
Sequence Timeout
You may wish to set the maximum time between bar code scans in an output
sequence. If that maximum time is not met, the output sequence operation is ter-
minated. Set the length (in milliseconds) for a timeout by scanning the bar code
below, then setting the timeout (from 1-65535 milliseconds) by scanning digits
from the Programming Chart on page 202, then Save. Default = 5000 msec.
Sequence Match Beeper
By default, the scanner beeps when a sequence match is found. If you want the
scanner to remain silent, scan the Sequence Match Beeper Off bar code below.
Default = Sequence Match Beeper On.
Partial Sequence
If an output sequence operation is terminated before all your output sequence cri-
teria are met, the bar code data acquired to that point is a “partial sequence.”
Scan Discard Partial Sequence to discard partial sequences when the output
sequence operation is terminated before completion.
Enter Sequence
Default Sequence
Sequence Timeout
Sequence Match Beeper Off
* Sequence Match Beeper On