User manual

Voyager 1250g User Guide 53
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252) on page 192, find the hex
value that represents the character you want to use to trigger scanning. Scan the
bar code below, then use the Programming Chart on page 202 to read the alpha-
numeric combination that represents that ASCII character. Scan Save to finish.
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the laser can
be programmed either to remain on and scanning, or to turn off. When End Char-
acter Activation After Good Read is enabled, the laser turns off and stops scan-
ning after a good read. If you scan Do Not End Character Activation After Good
Read, the laser remains on after a good read. Default = End Character Activation
After Good Read.
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and attempting to
decode bar codes when using Character Activation Mode. Set the length (in milli-
seconds) for a timeout by scanning the bar code below, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the Programming Chart on
page 202, then Save. Default = 5000 ms.
On
Activation Character
Do Not End Character
Activation After Good Read
* End Character Activation
After Good Read
Character Activation Laser
Timeout