User manual

Voyager 1250g User Guide 51
End Object Detection After Good Read
After a bar code is successfully detected and read from the scanner, the laser can
be programmed either to remain on and scanning, or to turn off. When End Object
Detection After Good Read is enabled, the laser turns off and stops scanning after
a good read. If you scan Do Not End Object Detection After Good Read, the laser
remains on after a good read. Default = End Object Detection After Good Read.
Object Detection Laser Timeout
You can set a timeout for the length of time the laser remains on and attempting to
decode bar codes after an object is detected. Set the length (in milliseconds) for a
timeout by scanning the bar code below, then setting the timeout (from 1-65535
milliseconds) by scanning digits from the from the Programming Chart on page
202, then Save. Default = 5000 ms.
Object Detection Mode On
Out-of-Stand
Do Not End Object Detection
After Good Read In-Stand
* End Object Detection After
Good Read In-Stand
Do Not End Object Detection
After Good Read Out-of-Stand
* End Object Detection After
Good Read Out-of-Stand
Object Detection Laser
Timeout In-Stand