User manual

44 Voyager 1250g User Guide
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good read.
For example, if you program this option to have five beeps, there will be five beeps
and five LED flashes in response to a good read. The beeps and LED flashes are in
sync with one another.
Note: The LEDs can also be programmed separately. See LED Settings on page 45.
To change the number of beeps, scan the bar code below and then scan a digit (1-
9) bar code from the Programming Chart on page 202, then scan Save. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or
error can be programmed from 1 - 9. For example, if you program this option to
have five error beeps, there will be five error beeps and five LED flashes in response
to an error.
Note: The LEDs can also be programmed separately. See LED Settings on page 45.
To change the number of error beeps, scan the bar code below and then scan a
digit (1-9) bar code from the Programming Chart on page 202, then scan Save.
Default = 1.
LED Indicators
The green and red LEDs can be programmed to be On or Off and at different
brightness levels to indicate various scanner states. Use the following bar codes to
program the LED indicators.
* Normal Beep
Short BeepShort Beep
Number of Good Read Beeps/LED Flashes
Number of Error Beeps/LED Flashes