User manual

Voyager 1250g User Guide 35

Timeout Retries

This setting limits the number of Communication Timeout retries. If the Timeout

Retries is set to 0, the transmission is terminated after the initial Communication

Timeout. Scan the bar code below, then set the number of retries (from 0-255) by

scanning digits from the Programming Chart on page 202, then scanning Save. (5

is the recommended setting.) Default = 0.

Communication Timeout Beeper

This selection programs the scanner to issue an error beep when a communication

timeout has occurred. The error beep sound is programmed using Number of

Beeps – Error (page 44). Default = On.

NAK Retries

This selection limits the number of NAK retries that can occur in ACK/NAK mode.

Scan the bar code below, then set the number of retries (from 0-255) by scanning

digits from the Programming Chart on page 202, then scanning Save. (5 is the rec-

ommended setting.) Default = 0, or disabled.

Support BEL/CAN in ACK/NAK

This protocol responds to <BEL> and <CAN> commands when in ACK/NAK mode.

The scanner sounds an error tone when a <BEL> command is sent from the host.

<CAN> terminates the transmission. Default = BEL/CAN Off.

Timeout Retries

* On

NAK Retries

BEL/CAN On