User manual

Voyager 1250g User Guide 29
Inter-Scan Code Delay
When your keyboard detects that any key is being pressed, released, or held down,
the keyboard sends a packet of information known as a “scan code” to your com-
puter. This selection allows you to adjust the delay between scan codes. Set the
length (in milliseconds) for a delay by scanning the bar code below, then setting
the delay (from 1-30) by scanning digits from the Programming Chart on page
202, then scanning Save. Default = 0 (800 µs).
<F0> Break Character
When your keyboard detects that any key is being pressed, released, or held down,
the keyboard sends a packet of information known as a “scan code” to your com-
puter. There are two different types of scan codes: “make codes” and “break codes.”
A make code is sent when a key is pressed or held down. A break code is sent when
a key is released. The following selections allow you to suppress or transmit the
character sequence of the break code. Default = Transmit.
Keyboard Wedge Defaults
If you want the custom keyboard wedge default settings restored to your scanner,
scan the Keyboard Wedge Defaults bar code below. This resets the scanner to the
custom default settings (see Set Custom Defaults on page 5). If there are no cus-
tom defaults, it will reset the scanner to the factory default settings. Any settings
that have not been specified through the custom defaults will be defaulted to the
factory default settings.
* Numeric Keypad Mode Off
Inter-Scan Code Delay
Suppress
* Transmit
Keyboard Wedge Defaults