User manual
16 Voyager 1250g User Guide
Datalogicâ„¢ Magellan
©
Bioptic
Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Datalogic
Magellan bioptic scanner auxiliary port configuration. This bar code sets the baud
rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 149 first, then scan the programming bar code above.
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR bioptic
scanner auxiliary port configuration. This bar code sets the baud rate to 9600 bps
and the data format to 7 data bits, Even parity, 1 stop bit and Message RTS/CTS
with timeout. The following prefixes are programmed for each symbology:
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults bar code on page 149 first, then scan the programming bar code above.
Datalogic Magellan Bioptic Settings
Symbology Prefix Symbology Prefix
UPC-A A Interleaved 2 of 5 b
UPC-E E0 Code 128 f
EAN-8 FF
GS1 DataBar
Omnidirectional
r
EAN-13 F
GS1 DataBar
Expanded
r
Code 39 a Codabar N
Code 32
Pharmaceutical
(PARAF)
a
NCR Bioptic Settings