User manual

14 Voyager 1250g User Guide
NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK mode.
Scan the bar code below, then set the number of retries (from 0-255) by scanning
digits from the Programming Chart on page 202, then scanning Save. (5 is the rec-
ommended setting.) Default = 0, or disabled.
Support BEL/CAN in ACK/NAK
This protocol responds to <BEL> and <CAN> commands when in ACK/NAK mode.
The scanner sounds an error tone when a <BEL> command is sent from the host.
<CAN> terminates the transmission. Default = BEL/CAN Off.
Verifone
®
Ruby Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Verifone Ruby
terminal. This bar code sets the baud rate to 1200 bps and the data format to 8
data bits, Mark parity, 1 stop bit and RTS/CTS no timeout. It also adds a line feed
(LF) suffix and programs the following prefixes for each symbology:
NAK Retries
BEL/CAN On
* BEL/CAN Off
Symbology Prefix
UPC-A A
UPC-E A
EAN-8 FF
EAN-13 F