User manual

Voyager 1250g User Guide 13

ACK/NAK Mode

Communication Timeout

This allows you to set the length (in milliseconds) for a timeout for the host ACK/

NAK response. Scan the bar code below, then set the timeout (from 0-65535 milli-

seconds) by scanning digits from the Programming Chart on page 202, then scan-

ning Save. Default = 2000 ms.

Timeout Retries

This setting limits the number of Communication Timeout retries. If the Timeout

Retries is set to 0, the transmission is terminated after the initial Communication

Timeout. Scan the bar code below, then set the number of retries (from 0-255) by

scanning digits from the Programming Chart on page 202, then scanning Save. (5

is the recommended setting.) Default = 0.

Communication Timeout Beeper

This selection programs the scanner to issue an error beep when a communication

timeout has occurred. The error beep sound is programmed using Number of

Beeps – Error (page 44). Default = On.

ACK/NAK Mode On

* ACK/NAK Mode Off

Communication Timeout

Timeout Retries

* On