User manual

CHAPTER
10
Voyager 1250g User Guide 185
MAINTENANCE AND
TROUBLESHOOTING
Repairs
Repairs and/or upgrades are not to be performed on this product. These services
are to be performed only by an authorized service center (see Product Service and
Repair on page xiii).
Maintenance
Your device provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following periodic checks
ensure dependable operation:
Clean the Device:
Reading performance may degrade if the scanner’s window is not clean. If the win-
dow is visibly dirty, or if the scanner isn’t operating well, clean the window with a
soft cloth or lens tissue dampened with water (or a mild detergent- water solution).
If a detergent solution is used, rinse with a clean lens tissue dampened with water
only. The scanner’s housing may also be cleaned the same way.
Inspect Cords and Connectors
Inspect the interface cable and connector for wear or other signs of damage. A
badly worn cable or damaged connector may interfere with scanner operation.
Contact your distributor for information about cable replacement. Cable replace-
ment instructions are on page 186.
Caution: Do not submerge the scanner in water. The scanner’s housing is
not watertight. Do not use abrasive wipes or tissues on the
scanner’s window. Abrasive wipes may scratch the window.
Never use solvents (e.g., acetone) on the housing or window.
Solvents may damage the finish or the window.