User manual

2 Voyager 1250g User Guide
1. Connect the appropriate interface cable to the scanner first, then to the com-
puter.
2. The scanner beeps.
3. Verify the scanner operation by scanning a bar code from the Sample Symbols
on page 201.
The unit defaults to a USB PC Keyboard. Refer to page 11 for other USB terminal
settings.
For additional USB programming and technical information, refer to “USB Applica-
tion Note,” available at www.honeywellaidc.com.
Connect with Keyboard Wedge
A scanner can be connected between the keyboard and PC as a “keyboard wedge,”
plugged into the serial port, or connected to a portable data terminal in wand emu-
lation or non decoded output mode. The following is an example of a keyboard
wedge connection: