User manual

Voyager 1250g User Guide 141
GS1 DataBar Limited
< Default All GS1 DataBar Limited Settings >
GS1 DataBar Limited On/Off
GS1 DataBar Limited Redundancy
If you are encountering errors when reading GS1 DataBar Limited bar codes, you
may want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the number of
errors. Note that the higher the redundancy count, the longer it will take to decode
the bar code. To adjust the redundancy, scan the GS1 DataBar Limited Redun-
dancy bar code below, then scan a redundancy count between 0 and 10 on the
Programming Chart on page 202. Then scan the Save bar code. Default = 0.
* On
Off
GS1 DataBar Limited
Redundancy