User manual

Voyager 1250g User Guide 117
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for UPC-A Addenda Required (see page 116).
Set the length (in milliseconds) for this timeout by scanning the bar code below,
then setting the timeout (from 0-65535 milliseconds) by scanning digits from the
Programming Chart, then scanning Save. Default = 100.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-A Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.
UPC-A Redundancy
If you are encountering errors when reading UPC-A bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the UPC-A Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the Programming Chart on page 202.
Then scan the Save bar code. Default = 0.
Addenda Timeout
* On
Off
UPC-A Redundancy