User manual

Voyager 1250g User Guide 99

Code 93 Redundancy

If you are encountering errors when reading Code 93 bar codes, you may want to

adjust the redundancy count. Redundancy adjusts the number of times a bar code

is decoded before transmission, which may reduce the number of errors. Note that

the higher the redundancy count, the longer it will take to decode the bar code. To

adjust the redundancy, scan the Code 93 Redundancy bar code below, then scan a

redundancy count between 0 and 10 on the Programming Chart on page 202.

Then scan the Save bar code. Default = 0.

Code 93 Message Length

Scan the bar codes below to change the message length. Refer to Message Length

Description (page 88) for additional information. Minimum and Maximum lengths

= 1-80. Minimum Default = 3, Maximum Default = 80.

Straight 2 of 5 Industrial (three-bar start/stop)

Straight 2 of 5 Industrial On/Off

Code 93 Redundancy

Minimum Message Length

Maximum Message Length

* Off