User manual

Voyager 1250g User Guide 91
Concatenation Timeout
When searching for bar codes during concatenation, you may wish to set a delay
used to find the next bar code. Set the length (in milliseconds) for this delay by
scanning the bar code below, then setting the timeout (from 1-65535 millisec-
onds) by scanning digits from the Programming Chart, then scanning Save.
Default = 750.
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Codabar Redundancy bar code below, then scan
a redundancy count between 0 and 10 on the Programming Chart on page 202.
Then scan the Save bar code. Default = 0.
Codabar Message Length
Scan the bar codes below to change the message length. Refer to Message Length
Description (page 88) for additional information. Minimum and Maximum lengths
= 1-80. Minimum Default = 3, Maximum Default = 80.
Concatenation Timeout
Codabar Redundancy
Minimum Message Length
Maximum Message Length