User's Manual

Components 3
E-EQ-RX2OGWW-A RX2 User’s Guid
Components
1. Power Switch
2. Input Power/Battery
Charger Connector
2
1
3
3. USB Client Connector
Figure 1 RX2 Connector Panel
1. RX2 Computer
2. Fork Truck Mounting
Bracket
3. Power LED
2
1
3
4
4. Antenna Enclosure
Figure 2 RX2 Components
Quick Start
Note: The RX2 is assembled with an optional internal battery pack (if ordered) and radio card
installed before shipment.
This section’s instructions are based on the assumption that your new system is pre-configured
and requires only a power source.
In general, the sequence of events is:
1. Provide a power source for the RX2:
• Connect a fully charged external battery pack.
-or-
• Connect an external power source to the unit (if required).
-or-
• Use the optional internal battery pack (the internal battery pack, if ordered, must be
fully charged before use).
2. Flip the power switch to On.
Note: Do not connect a tethered scanner cable to a USB-C labeled port. This port cannot
power a tethered scanner.
Preliminary - Draft 08