User's Manual

18 The Power LED
RX2 User’s Guide E-EQ-RX2OGWW-A
The Power LED
The RX2 has a power status LED on the font of the antenna enclosure.
Figure 16 Power LED
The LED indicates the status of the RX2:
Off
Indicates the RX2 is switched off or no power is applied to the RX2.
The LED is off when the battery charger is attached to the RX2.
Solid Green
Indicates the RX2 is booting and battery power is good (or DC power
is attached).
Solid Red
Indicates the RX2 is booting and battery power is low.
Flashing Green
Indicates the RX2 has finished booting and is ready for use. Battery
power is good (or DC power is attached).
Flashing Red
Indicates the RX2 has finished booting and is ready for use. Battery
power is low.
When the power LED switches from green to red, this indicates approximately 30 minutes of
battery power remains in the battery pack (either internal or external).
Before the 30 minutes expire, action should be taken:
• The RX2 battery charger can be used to charger either the internal or external battery
pack. The RX2 cannot be used while the battery is charging.
• A fresh external battery pack can be used to replace a depleted external battery pack
or to supplement an internal battery pack when charging time cannot be allotted.
Additional Low Power Warning
In addition to the LED turning red, other indications of a low battery may be present depending on
your configuration:
• A low battery buzzer may sound (N/A on early units).
• The network host may be configured to monitor for RX2 units with a low battery.
Please consult your system administrator for details.
Preliminary - Draft 08