User's Manual
Table Of Contents
8 Mounting RX2 Accessories
RX2 User’s Guide E-EQ-RX2OGWW-A
1. Install the bracket by placing the hook (at the bottom of the bracket) over the lip of a Cascade
E or F series side shifter.
2. Slide the RX2 over to the desired position.
3. Secure with (4) 1/4-20 set screws in the threaded holes on the top surface of the bracket.
Thread a lock nut onto each set screw. Using an Allen wrench, tighten all four set screws to
an equal depth, but do not tighten the locking nuts yet.
4. After all set screws have been tightened, recheck and retighten all screws. Tighten the
locking nut while holding the set screw tight with an Allen wrench.
Mounting RX2 Accessories
Bracket for Coupler (Internal Battery and Charger or External Battery)
??
Bracket for Terminal Block (DC to DC Power Supply)
??
DC to DC Power Supply
??
Preliminary - Draft 08