User's Manual

E-EQ-RX2OGWW-A RX2 User’s Guide
Installation
Introduction
The general installation procedure consists of
1. Mounting the RX2 and any accessories to the forklift truck.
2. Providing a power source to the RX2:
• Use the optional internal battery after it is charged with the RX2 Battery
Charger
• Use an external battery pack after it is charged with the RX2 Battery
Charger
• Use a direct connection to 12V DC vehicles
• Use a DC to DC converter for 24 – 60 VDC vehicles
Please read Appendix A, “Regulatory Notices and Safety Information” before installation.
Mounting the RX2
2
3
4
1
1.
2.
3.
4.
Set Screws (4 each)
Lock Nuts (4 each)
Set Screw Holes (4)
Hook
Figure 4 Mounting Provisions
To install the RX2:
Preliminary - Draft 08