User's Manual
Table Of Contents
- Notices
- Revision Notice
- Table of Contents
- Illustrations
- Introduction
- Overview
- Laser Warnings and Labels
- Components
- Quick Start
- About Lithium-Ion Batteries
- RFID Introduction
- Insert Main Battery
- Attach Handstrap (Optional)
- Attach the Stylus Clip (Optional)
- Attach to Hip-Flip (Optional)
- Connect External Power Supply (Optional)
- Connect Audio Jack (Optional)
- Power Button
- Tapping the Touchscreen with a Stylus
- Touchscreen
- Set The Audio Speaker Volume
- Enter Data
- Getting Help
- The MX3X Hand Held Computer
- Key Maps
- Regulatory Notices and Safety Information
- Index
38 Storage Cradles
Tethered Scanner and a Cradle
To use a tethered scanner connected to the RS232 port on the cradle, the cradle must be powered
off, the cable removed and the cradle powered up. Then, the tethered scanner can be attached to
the cradle’s serial port.
The MX3-RFID and Cradles
The MX3X with an RFID module (MX3-RFID) cannot fit in the MX3 charging cradles. There is a
passive vehicle cradle available for the MX3-RFID device that secures the MX3-RFID device to
the cradle only. See “Accessories”.
MX3-RFID battery charging and communication is not available in the MX3-RFID passive
vehicle cradle unless the mobile device is connected to external power through the power jack in
the endcap. The passive vehicle cradle does not have LEDs or indicators. It does not require DC
power connection.
MX3X User’s Guide E-EQ-MX3XOGWW-C