User's Manual
Table Of Contents
- Notices
- Revision Notice
- Table of Contents
- Illustrations
- Introduction
- Overview
- Laser Warnings and Labels
- Components
- Quick Start
- About Lithium-Ion Batteries
- RFID Introduction
- Insert Main Battery
- Attach Handstrap (Optional)
- Attach the Stylus Clip (Optional)
- Attach to Hip-Flip (Optional)
- Connect External Power Supply (Optional)
- Connect Audio Jack (Optional)
- Power Button
- Tapping the Touchscreen with a Stylus
- Touchscreen
- Set The Audio Speaker Volume
- Enter Data
- Getting Help
- The MX3X Hand Held Computer
- Key Maps
- Regulatory Notices and Safety Information
- Index
26 Touchscreen Display
Touchscreen Calibration
If the touchscreen is not responding properly to pen touch taps, the touchscreen may need to be
recalibrated. Press <Ctrl>+<Esc> to force the Start Menu to appear, if needed. Contact your
System Administrator for assistance.
To recalibrate the screen, select Start | Settings | Control Panel | Stylus | Calibration.
Figure 22 Touchscreen Recalibration
To start, tap Recalibrate. Follow the instructions on the screen and press the Enter key to save the
new calibration settings or press <Esc> to cancel or quit.
See the "MX3X Reference Guide" for complete instructions.
Cleaning the Glass Display/Scanner Aperture
Note: These instructions are for components made of glass. If there is a removable protective
film sheet on the display screen, remove the film sheet before cleaning the screen.
Keep fingers and rough or sharp objects away from the scan aperture and display. If the glass
becomes soiled or smudged, clean only with a standard household cleaner such as Windex(R)
without vinegar or use Isopropyl Alcohol. Do not use paper towels or harsh-chemical-based
cleaning fluids since they may result in damage to the glass surface. Use a clean, damp, lint-free
cloth. Do not scrub optical surfaces. If possible, clean only those areas which are soiled.
Lint/particulates can be removed with clean, filtered canned air.
MX3X User’s Guide E-EQ-MX3XOGWW-C