User's Manual
Table Of Contents
- Notices
- Revision Notice
- Table of Contents
- Illustrations
- Introduction
- Overview
- Laser Warnings and Labels
- Components
- Quick Start
- About Lithium-Ion Batteries
- RFID Introduction
- Insert Main Battery
- Attach Handstrap (Optional)
- Attach the Stylus Clip (Optional)
- Attach to Hip-Flip (Optional)
- Connect External Power Supply (Optional)
- Connect Audio Jack (Optional)
- Power Button
- Tapping the Touchscreen with a Stylus
- Touchscreen
- Set The Audio Speaker Volume
- Enter Data
- Getting Help
- The MX3X Hand Held Computer
- Key Maps
- Regulatory Notices and Safety Information
- Index
Insert Main Battery 9
Insert Main Battery
Press the Power button after the battery is inserted into the battery compartment.
Note: New batteries must be charged prior to first use. This process takes up to four hours in
an LXE Multi-Charger Plus and eight hours with an external power source attached to
the mobile device.
Figure 9 Battery Contacts
The Main Battery compartment is located at the bottom of the back of the computer. The arrows in
the figure titled “Battery Contacts” point to the battery contacts in the computer. The figure titled
“Main Battery” show the cradle and charger contacts on the back of the main battery.
Figure 10 Main Battery
Place the battery in the compartment, making sure the side of the battery with six contacts matches
up with the battery contacts in the computer battery compartment. Do not slide the battery
sideways into the compartment.
Firmly press the battery into the compartment until the Retaining Clip on the battery clicks. The
battery is now securely fastened to the computer. The computer draws power from the battery
immediately upon successful connection.
Check Battery Status
Tap the Start | Settings | Control Panel | Power icon. Main and backup battery level, status and
Power Scheme timeout setting options are displayed.
E-EQ-MX3XOGWW-C MX3X User’s Guide