User's Manual

Safety FlexLine
3
in accordance with national, local and company regulations. The entire electrical
installation shall be carried out in accordance with the national requirements for
electrical equipment to be installed in hazardous areas.
2.3.5 Additional information
If you require additional information, contact Enraf or its representative.
2.3.6 Environmental conditions
Observe the environmental conditions for the temperature and the pressure. Refer to
the chapter “Technical data”.
2.4 Liability
The information in this installation guide is the copyright property of Enraf B.V.,
Netherlands. Enraf B.V. disclaims any responsibility for personal injury or damage to
equipment caused by:
• Deviation from any of the prescribed procedures,
• Execution of activities that are not prescribed,
• Neglect of the safety regulations for handling tools and use of electricity.
The contents, descriptions and specifications in this installation guide are subject to
change without notice. Enraf B.V. accepts no responsibility for any errors that may
appear in this installation guide.
NOTE
Refer to EN IEC 60079-14 or NEC (NFPA70).
Warning!
Only certified technicians are authorized to make changes on the
SmartRadar configuration. All modifications must be in accordance to
the guidelines as set forth by Enraf. Modifications not authorized by
Enraf will invalidate the approval certificates.