User's Manual

Installation FlexLine
35
4.13 Finishing installation without SmartConn
4.13.1 Close the cover of the device
1. Close the cover. Make sure that the cover does not squeeze any cables inside the
housing.
2.Tighten the 16 bolts of the cover. Tighten the bolts crosswise. Use an Allen key
(8mm).
4.13.2 Replace the top cover
1.Open the display cover.
2.Place the 2 hooks at the rear of the top cover behind the axis of the cover.
3.Push down the top cover carefully.
4.The installation is now completed.
Warning!
Tighten all bolts with a torque of 30 Nm (711 ft·lb
f
) to prevent danger of
explosion!
Caution!
Always clean the flange of the housing and the cover, before you
close the cover.
Warning!
Make sure the flange of the housing is clean and the O-ring is not
damaged before closing the cover.