User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 43
6.4.5.2.4.2 Ranges Tab
This tab contains the settings for Engineering units.
Permitted Mode With these check boxes you can select the permitted modes for the transducer block.
Process Variable If the transducer block is set to manual mode, you can manually overwrite the
parameter (such as level).
This is not standard within OneWireless. The manual value entered here will also be
available in the FlexConn environment. If the Transducer block is not in Manual mode
an error code will be generated after pressing the OK button.
Parameter Description
EU at 100% Not used in The SmartRadar FlexLine
EU at 0% Not used in The SmartRadar FlexLine
Units Index In this field you can select the required engineering unit from the list of available units.
(Level units for the level TB, and temperature units for the Temperature TB)
Note: For supported units, see 6.4.5.2.8.
Parameter Description