User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 37
6.4.3.2 Preparing the Radar
Before adding a radar to a one wireless Network, old security
information must be removed from the radar. To prevent this from
happening by accident, this functionality is only available via the
SmartView. To erase the security information:
☛ Go to
[Menu] > [Commands]
☛ Enter the password
☛ Go to the HCI-1WL
☛ Select
[Board] and issue the [Restore Default] command.
6.4.3.3 Authentication
☛ Ensure the OneWireless Network is operational, including running
Key Server Manager (KSM) software, and at least 1 multi-node
configured as gateway.
☛ Use the KSM to write security information to a memory card. See the
Key Server Manager manual for instructions on how to use the key
server. For a sample screen, see FIGURE 6-5.
☛ Insert the memory card into the memory card slot of the HCI-1WL
device.
☛ Make sure to fully close the device if it is installed in an explosion
hazardous area.
☛ Switch on the device
The device will now automatically join the OneWireless network.
You can follow the authentication/joining process by navigating to the
correct page on the SmartView, see 6.4.8.1. Or by using Engauge, see
6.4.9.1, if there is also a wired connection available.
If the message
[NOREDUN] or [CONNECT] does NOT become visible, the
authentication failed.
☛ If authentication failed, verify that the wireless network is operating
correctly, and try again with a new security key.
Key Server
Manager