User Manual

Commissioning

Part No.: 4417.762_Rev07 SmartRadar FlexLine

Service Manual 6 - 1

CHAPTER 6 COMMISSIONING

6.1 General

6.1.1 Introduction

This chapter gives an overview of the commissioning information per

FlexConn module.

NOTE: Not all modules are always present.

Commissioning a FlexConn module is done by setting software

parameters, the so-called entities (see Chapter 3), to the desired

specific values. This can either be done by using Engauge or

SmartView (see Chapter 4).

6.1.2 Text Conventions

In contrast with explanatory text, all instruction text will be preceded by

☛.

All

[Entity] and <entity-related> text is recognizable formatted. When - for

instance - all required FlexConn module entities are commissioned, the

[Board Commissioned] entity will display <True>. If not, it will display <False>.

All

!Command! text is also recognizable formatted, If - for instance - an

!Activate! command is given, the result will be <Activated>.

In this chapter, each commissioning-instruction text is recognizable by

the Engauge/SmartView icon in the margin.

When a commissioning instruction or command cannot be initiated by

SmartView, the icon will be given.

When a commissioning instruction or command can only be initiated via

SmartView, the SmartView-only button is visible (left).

In some cases the Wireless Builder and/or the Key Server Manager

application(s) are used. This is indicated by a corresponding button

(left).

Wireless

Builder

Key Server

Manager