User Manual

Service Tools
SmartRadar FlexLine Part No.: 4417.762_Rev07
4 - 18 Service Manual
4.2.2 Using Engauge
After starting up the Engauge application, first the specific transmission
address of the concerned SmartRadar FlexLine system must be set
correctly. Also the transmission speed (baudrate) must be set.
After this is done, Engauge’s explorer appears, and each FlexConn
module of the concerned SmartRadar FlexLine system is visible on the
left panel. See FIGURE 4-19.
Now each individual SmartRadar FlexLine module can be controlled by
double-clicking on the module’s icon on the left panel. The so-called
“board descriptor” is then loaded and a screen with “tab” pages
appears.
ESF09-0001
FIGURE 4-19 Example (1) of an Engauge screen