User Manual

System Architecture
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 3 - 13
3.5.1 Status Entities in Engauge
Each board descriptor user interface starts with the tab page “Status”.
On this tab page the “Health” and “Commissioning” entities for the
whole module and the individual functions are placed.
3.5.2 Generic Entities in Engauge
The “Status” tab page is always followed by the “Generic” tab page, on
which the general commands and diagnostics entities are placed.
3.5.3 Board-specific Entities in Engauge
The “Generic” tab page is always followed by the “Board specific” tab
page, on which the board-specific entities are placed. These entities are
specific for each individual FlexConn module type. The board-specific
entities are further described in Chapter 6 - Commissioning.
3.5.4 Specific Entities on Engauge
After the board-specific tab page, for each implemented function on the
concerned FlexConn module a specific tab page follows.
For example, for the FII-DO module, the below listed specific tab pages
will be present:
 Relay 1
 Relay 2
 Relay 3
 Relay 4
In case of complex functions, extra tab pages may exist, containing
those specific functions involved.
The specific entities are described in Chapter 6 - Commissioning.
3.5.5 Function-generic Entities on Engauge
The function category “generic entities” are placed at the bottom of each
function tab page in Engauge.
For each category (sensor, digital I/O, communication, display), the
basic Engauge version will have only one entity:
“Function identification”.
With this entity, the user can change the function name, which will then
become available on the SmartView Primary Value screen and in
Engauge as well.