User Manual

System Architecture
SmartRadar FlexLine Part No.: 4417.762_Rev07
3 - 10 Service Manual
3.4.2 Status Entities on SmartView
Choosing sub-menu “commissioning” from the main menu, a survey
results of all FlexConn modules present in the SmartRadar FlexLine
system.
Each module is followed by an indication for the “Health” and the
“Commissioned” status respectively. In case of an unreliable or fault
situation, the “Information” column shows an information code in
addition. This information code reveals the specific reason about the
current status.
This diagnostics goes for each individual FlexConn module. See
example below.
 The “Health” indication can be:
“G” = Good
“U” = Uncertain
“B” = Bad
 The “Commissioned” indication can be:
“Y” = the most important entities are set correctly
“N” = the most important entities are not set correctly
Starting from the “commissioned” menu and choosing the specific
FlexConn module, the above diagnostics is repeated for each module
function. See example below.
over range over range
under range under range
no data available no data
un-initialized no init
killed killed
H C I
FII-DO G N
FII-DO:>
board H C I
Relay 1 G N
Relay 2 G Y
Relay 3 U Y nnn
Relay 4 B Y
Status Category Display Text