User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 161
6.11.4.4.3 Engauge * Ambient temperature * Tab
NOTE: Some settings for ambient temperature calculations
are shared via the product temperature settings.
☛ The following entities can be set by Engauge or SmartView for a
specific functioning of the FII-RTD module in an instrument. The
default values are available after initialization of the non volatile
memory; so check each entity for its correctness.
[Alarm test] Activates and selects at the
same time the Alarm test (if
enabled with the
[Alarm test
enable]
listed before, and the
4 alarm thresholds are
properly set).
[No Alarm]
[High High alarm]
[High Alarm]
[Low Alarm]
[Low Low alarm]
<No Alarm>
[Function identification]
The name of the current
function of this module.
This name is visible on the
SmartView.
13 characters <Vapour temp.>
Name Explanation Value Range Default
[High High alarm]
[High Alarm]
[Low Alarm]
[Low Low alarm]
4 Thresholds for activating
a related alarm status in the
Primary Value
floating point numbers:
<-x.x .. +x.x>
<+1.0E22>
[Alarm test enable]
Enables (if activated, see
next listed entity) the
simulation of one of the 4
alarms for a minute, by
simulating the actual
measured Primary Value is
below or above the alarm
threshold.
<enable>
<disable>
<disable>
[Alarm test]
Activates and selects at the
same time the Alarm test (if
enabled with the [Alarm test
enable]
listed before, and the
4 alarm thresholds are
properly set).
[No Alarm]
[High High alarm]
[High Alarm]
[Low Alarm]
[Low Low alarm]
<No Alarm>
[Function identification]
The name of the current
function of this module.
This name is visible on the
SmartView.
13 characters <Ambient temp.>
Name Explanation Value Range Default