User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 153
ESF09-0006
FIGURE 6-41 Temperature range check feature
 A median filter can be turn on or off, which eliminates spikes of each
individual calculated spot tempearture.
 An averaging constant filter can be turned on or off, which takes a
certain part of the previous calculated average temperature and a
certain part of the new calculated temperature into account.
 Low element usage with following possible sub-settings can be
applied:
• No exclusion
• Static exclusion
• Dynamic exclusion
These settings are then to be refined further with:
• Exclude zone
• Smoothing level
• Low element behaviour

See FIGURE 6-42 on next page.
range check result = OKspot element
in fail*)
spot element
in fail
(3 retries)
spot element
in fail
(3 retries)
spot element
in fail*)
*) if
[Element skipping]
is enabled,
“spot element in fail”
can be skipped
*) if
[Element skipping]
is enabled,
“spot element in fail”
can be skipped
checking range if [Temperature range check] is enabled
permanent check permanent check
upper
shortcut
range
lower
temperature
range
upper
temperature
range
lower
not-connected
range